You Pay for Power--Read Your Meter

Spend any amount of time in a commercial RV park and you’re apt to get a power bill. Since power is expensive anywhere, it’s a bitter pill for RVers when they are often presented with a bill for rates higher than the locals pay. We’ve all heard the, "Cost of reading the meter," "Administrative overhead," "Huh?" excuses.

How do you know if you’re actually being billed for what you’ve used? In many parks, old style "clock" type electric meters are used, and many folks just don’t have a clue as to how to "read" them. Digital meters are a lot easier, but not near as common.

Here’s how to read a clock type meter.

Remember that each of the hands represents a single digit of the present reading. It’s helpful to recall that some hands turn clockwise, others counter-clockwise. When the hand is between numbers, that hand is always read to the lower number.

In the picture, the reading on the meter is 43304. It may be difficult to discern that the second three (or the 3rd hand reading from left to right) is really a 3. The giveaway is simple: If the hand to the right of the one in question is past the zero, then the hand in question is to be read as higher. And remember, When meters are read they are NOT reset to zero.

So when you "check in" to your RV site, read the meter and write down the figures. To practice, you might read it every day to get the hang of it, and to see how little power RVers use--unless of course, you’re running the air conditioning! To know how much power or "killowatts" you’ve used, simply subtract the earlier reading from the present reading. Knowledge, as they say, is power.